SPI processing of PLC data

Payload calibration (PLC) data for SPI scientific analysis

Find below a list of science windows which can be analysed using the SPI scientific analysis (starting from the prepared data and running up to imaging and spectra level). All data are taken during the ESTEC payload calibration in January and February 2002.

NOTE! All science windows which end with 1.000 are taken in SLEW mode, thus should not be used for running SPIROS / SPISKYMAX (run blc_sa only up to the BIN_I level!). The PLC data are not fully tested up to now. You will probably have some problems when running the SPI analysis software on this data. Only a few pointings have been tested up to now using SPI scientific analysis:

List of SCWs for scientific analysis
SCW ID SPI mode Remarks
001000260010.000 OPER strong 80 keV line
001000270010.000 OPER strong 80 keV line
001000280010.000 OPER strong 80 keV line
001000290010.000 OPER problems with processing
001000500010.000 OPER 573 GTI intervals in this pointing
001000500020.000 OPER 608 GTI intervals in this pointing
001000500030.000 OPER 594 GTI intervals in this pointing
001000520010.000 OPER GTI intervals in this pointing
001000520020.000 OPER GTI intervals in this pointing
001000520030.000 OPER GTI intervals in this pointing

The data cannot be found on the ISDC system anymore

In case of questions and comments: contact Volker at the GSFC.