skip to content
The RXTE Learning Center
| Index Page | About RXTE | About X-ray Astronomy | RXTE Discoveries |

| Images and Movies | Education | Tour the ASM Sky | Other Resources | What's New? |

bar

instructions

bar

1. Cut entire body out. Make sure you don't inadvertently cut off anything that is attached to the body of the model.

2. Cut out the two grey circles located on the body. This is easiest when done with an Exacto knife or a single hole punch, but scissors can also be used.

grey circles to cut out

3. Slice the bold line where Tab A connects to the body.

slice the bottom line

4. Make a slit by slicing the line on Side Panel 1 and the slits located both on Side Panel 2 and the body. The arrows on the diagram show where you should cut.

side panels

bar

back arrow
Previous
 		next arrow
Next

bar

| Index Page | About X-ray Astronomy | RXTE Discoveries | Images and Movies |

| Education | Tour the ASM Sky | Other Resources | What's New? |

The RXTE Learning Center is a service of the Astrophysics Science Division at NASA/GSFC.

Meet the RXTE Learning Center Team!     What is the 'R' in RXTE?

Responsible NASA Official: Phil Newman
Web Curator: Dr. James Lochner

Privacy Policy and Important Notices.

This file was last modified on Monday, 16-Dec-2002 12:59:37 EST